Lassco FMMS-3 Three Spindle Manual Lift Paper Drill It has a 2" drilling capacityEasy to adjust moveable head designRugged mechanical lift table which smoothly traverses in either directionBuilt for ease in operation and maximum production performance
The Lassco Spinnit FMMS-3 Paper Drill is identical to the FMM-3 except it has Stationary Drill Heads set for drilling three holes 4 1/4" center-to-center.
All floor model drills include:
MS-1 drill sharpenerSpin-Eze drill bit lubricantSet of 5/16 inch drill bitsSharpening stoneChip clearer
Table size: 15" x 32"Base footprint: 15" x 15"Table heigh: 35-1/2"Overall height: 52"Overall width: 32"Overall depth: 26"Max drilling capacity: 2"Motor: 3/4 HP, 115 voltsActual weight: 178 lbs.Shipping weight: 275 lbsShipping dimensions: 48" x 40" x 60"Ships via: LTL Truck
Some Pointers and Tips on Drilling: USE A SHARP DRILL BIT AT ALL TIMES. Generally, a drill bit can be used for approximately four (4) hours of use before it needs to be sharpened. Apply light pressure when sharpening. Too much pressure may cause flaring of the tip which renders the bit unusable. Sharpening stones are also recommended to debur the outside cutting edge of the your drill bits for better performance. Use of Drill-Ease or Spin-Eze lubricant is required. Finally, purchase drill blocks to stop the drill bit after it penetrates the drilled material.
AccessoriesDrill stripsStyle A 2" hollow drill bits