Lassco Spinnit EBM-2.1 E-Z Glide Table-Top Paper Drill
The Lassco Spinnit EBM-2.1 Bench Paper Drill or Table Top Paper Drill is the Lassco EBM-2 improved with the E-Z Glide table system that uses pattern bars which allows for quick movement from hole to hole for multi-hole drilling. The bench model, table top design makes it easy to place the unit almost anywhere in your workspace. A release lever is positioned on each side of the traversing table for right or left-handed operation.
An adjustable side stops allow you to trap your product to prevent misalignment!
Easy to set up and use with minimal installation necessary.
SPECIFICATIONS
Table size: 18 x 12 Inches
Base Footprint: 12 x 13 1/2 Inches
Table Height: 3 1/2 Inches
Maximum Drilling Capacity: 2 Inches
Motor: 1/4 Horse Power
Voltage: 115 Volts
Actual Weight: 66 lbs.
Shipping Weight: 101 lbs.
Ships by Truck
Included with the EMB-2.1 Table -Top Paper Drill are:
A Sharpening Store
A Chip Clearer
A 1 ounce Bottle of Spin-Eze Drill Bit Lubricant,
A 5/16" Diameter Paper Drill Bit, and
Five patterns for multi-hole drilling. The sizes
Iare as follows:
Blank (customizable)
3 holes, 2-3/4" apart center to center
3 holes, 3-1/2" apart center to center
2 holes, 2-3/4" apart center to center
3 holes, 4-1/4" apart center to center
ACCESSORIES
Drill Strips
Style A - 2 Inch capacity Hollow Paper Drill Bits
Some Pointers and Tips on Drilling: USE A SHARP DRILL BIT AT ALL TIMES. Generally, a Drill Bit can be used for approximately four (4) hours of use before it needs to be sharpened. Apply light pressure when sharpening. Too much pressure may cause flaring of the tip. (Once a Drill Bit has a flared tip, it becomes defective.) Three types of Drill Sharpeners are available. We recommend you purchase a sharpener and also an extra Drill Bit for each size that you use to insure you can finish a job in the event a Drill Bit breaks. USE A SHARPENING STONE to debur the outside cutting edge of the your Drill Bits for better performance. LUBRICATE DRILL BITS OCCASSIONALLY - use Drill-Ease or Spin-Eze. While the drill is running, simply touch the Drill-Ease stick to the Drill Bit or brush on the Spin-Eze. This will allow for a smoother cut. USE DRILL BLOCKS. When drilling, a Drill Bit must stop slightly above the drill block when lowered. Replace worn out drill blocks regularly to ensure proper drilling.
|
English
| 
Espanol
| 
Francais
| 
Deutsch
| 
Italiano |
